🥂Readyswap TG Volume and SuperSignals Autotrader

Under Development

Volume Signal AutoTrader

ReadySwap volume signal autotrader watches the Mempool. If a fresh token is getting lots of buys it will enable and auto-buy that token - jumping aboard the train.

You have a range of filters available, though Volume is the primary one.

Volume

Set your Transaction Volume, required to trigger the auto-buy. eg 40 mempool transactions.

Checksum: If you have a dev using a common checksum (source from TUFEXT.com) input here as your filter.

Name or Symbol: If you have a contract name or symbol, but don't have the CA yet, enter it here, perhaps with a volume of 1 tranaction. When Volume is hit, you will auto-buy. *Not so useful on popular launches as copy-cat scam contracts will be launched, so use with caution - though risk getting 2-3 rugs and getting paid off big over a token that runs up only for months could be a worthwhile strategy.

Buy Tax and Sell Tax: You can set HIGH and LOW figures for both buy or sell taxes.

In this example, Volume auto-buyer would only trade tokens with a buy tax Below 1% (skipping all the 0% and 0.6% tokens that attract MevBots), and those with buy tax above 25%

SL/TP: Pre-set your StopLoss and Take profit Targets

Readyswap SuperSignal

SuperSignals aggregates 100 high-alpha wallets and when correlation parameters are hit - eg number of wallets entering/ value as well as filtered by project quality, it will generate a Buy signal on newly launch tokens giving the trader early entry to new token launches.

With Readyswap you can integrate SuperSignals with Autotrader, and also set Take Profit and Stop Loss targets for those auto-generated entries.

SuperSignal Filters

You can add the same Volume filters to TUF SuperSignals as you have with Volume Autotrader

Volume, Name, CheckSum, Buy tax, Sell Tax.

Find out more about TUF SuperSignals at tufext.com

Stop Loss and Take Profit targets

Just like Volume autotrader, you can add your preset take profit targets and stop loss targets to auto-trigger when hit. The option to setup multiple targets, for differing amount of tokens is available.